How To Backwash Intex Pool Filter
Cool How To Backwash Intex Pool Filter 2022. After backwashing, use the rinse setting for a few minutes before rinsing. And while you’re at it, make sure the filter is never on while you’re turning that multiport valve:
1/12 x 1/12 inch rubber coupler with clamps. I seem to get this question a lot so why not make a video on how i do it. Set the filter to “backwash” and keep the handle locks in place.
To Make Your Solution, Combine 1 Cup Of Trisodium Phosphate (Tsp) And 4 Cups Of Water,.
Turn on the pool pump. Rinse runs water through the filter the normal way. Intex krystal clear sand filter.
1 Inch Pcv Pipe About 4 To 6 Inches Long.
Connect a hose or pipe to the discharge port. Select the “backwash” position on your multiport valve handle. Turn off your pool’s filter.
Switch The Multiport Valve To Backwash.
You must rinse the filter for a decent amount of time or the stuff will stay in the filter and go back into your pool when you. If your pool drains into your garden/yard etc and you have a backwash hose attached to the drainpipe then roll it out and position the end where you want. Check out the electrical fire i had on the pump:
The Filter Is Used To Send Water Through It In The Normal Direction On This Setting, But It Is Instead Sent To.
Turning on the pool pump will push the water into the filter and through the multiport valve. I seem to get this question a lot so why not make a video on how i do it. It uses a normal operating filter pressure to clean.
Rinse The Filter With A Hose.
The water goes in whichever direction the valve points. 1/12 x 1/12 inch rubber coupler with clamps. Turn the pool filter system off.
Post a Comment for "How To Backwash Intex Pool Filter"