Hayward Pool Heater How To Turn On
Review Of Hayward Pool Heater How To Turn On 2022. Turn pump, gas supply, and heater power “off”. Disconnect the blower connector from the control module.
Remove the wire leads from the water pressure switch and check for continuity across the switch while the pump is running.the lo code is not caused by a water. If the pilot light is not lit, the gas will not flow to the burner. Turn pump, gas supply, and heater power “off”.
To Troubleshoot The Heater For This Problem, Check The.
Turn the gas valve knob to the “on” position. Once you’re signed in, click on the “control” tab at the bottom. Press and hold the up and down buttons simultaneously, according to the stanley louis company.
You Find Hayward Authorized Servicers By Going To.
Remove the four screws from the retaining air deflector, and. In addition to heating your pool or spa, you can enhance the warming effect by adding a cover to maintain a comfortable water temperature. It was working with no issues a few days ago.
Hold The Buttons Until The Indicator Light Rapidly Flashes And The Digital Display.
If the pilot light is not lit, the gas will not flow to the burner. Turn the breaker “off” and then the “on” position. If the circuit breaker does not.
This Should Ignite The Pilot.
Hello all, i have a hayward h100 pool heater running off of natural gas. Shutting off the plumbing valves would cease the flow of water, which would cause the ignition to fail. Hold the knob down for a minute, so the pilot generator heats up, then release.
The Components Of A Hayward Pool Heater Are Also Very Similar To Gas Heaters Made By Other Manufacturers.
You should turn the gas off to the heater to eliminate any possibility of it turning on, and call an authorized servicer immediately. If closed, the lo is probably not. Allow the burners to cool before turning off.
Post a Comment for "Hayward Pool Heater How To Turn On"